Your cart is empty.
Your cart is empty. Lucasng Marine Center Water Pump Impeller Kit
Fits your Mercury F40‑60 4-stroke Bigfoot/Command Thrust outboard,
60 hp 2‑cycle BigFoot (serial number 0D000750 and above).
75/90/115 4-stroke outboards,
150 EFI 4-stroke outboards
70/75/80/90 hp 2‑cycle outboards (serial number 0A996142 and above).
100/115/125 Hp. 2‑cycle (4 cylinder) models having pump cover screws without insulators.
It also fits V‑200/225/250 (3.0L) 2‑cycle outboards.
Fits all 4-cylinder and 6-cylinder Verado (with 4.80 dia. torpedo gearcases) outboards.
Also fits MerCruiser Alpha One Gen II drives (serial number 0D469859 and above).
See your owner’s manual for replacement schedule.
See your service manual for installation instructions.
Jamie Chester
Reviewed in the United States on April 28, 2025
The kit worked great. Had all the parts needed
Rj
Reviewed in the United States on April 22, 2025
The item was complete but did not fit my motor after disassembly of the water pump and noticed the gaskets were not a fit. Not the sellers fault but wrong part numbers on my part.
Matt
Reviewed in the United States on April 10, 2025
Great fit and function. I was confused about the gasket placement. I only removed two gasket but this kit comes with three. Made educated guess and it working great. No instructions on placement of parts.
nazdackster
Reviewed in the United States on September 29, 2024
Easy to install, no issues. On mine, the piece that failed was the seal that slips over the drive shaft. That seal gets pressed down along the shaft and against the face of the metal housing where the impeller goes. The impeller actually looked pretty good considering it was probably 10 years old. Don't hesitate, it's not that hard a job to do. Once you get it apart, it's a good time to blow water and compressed air the wrong way through the system to help clear out any junk in the cooling passages too. Mine works so much better now that I cleared it out like that.
GUNDOG 2010
Reviewed in the United States on May 6, 2024
Bought this for a Mercury 115 HP 2 stroke outboard. All the parts fit as they should. Pumps water perfectly
Milton
Reviewed in the United States on March 7, 2024
Works great, easy install on 60 mercury
Lori Mehmen
Reviewed in the United States on December 20, 2024
Works great
Jan
Reviewed in the United States on April 9, 2024
All necessary parts, with a few extras that were not needed. I only added some marine grease to finish the installation.
Recommended Products
