Your cart is empty.
Your cart is empty.Product Description
Rafael Paredes
Reviewed in the United States on May 21, 2025
The shipping was excellent, we always recommend
Patrick
Reviewed in the United States on March 24, 2025
Works great.
Matt Dobgoai
Reviewed in the United States on March 23, 2025
Seems to work ok - the hardware supplied would have been a hassle to install Allen head screws…. I used the existing bolts - just make shure you pull the manifold back some so you can put the bolt in. Other than that it’s bolt and go.
FLC
Reviewed in the United States on March 21, 2025
Seems to be fine. No issues at all.
eddy
Reviewed in the United States on March 13, 2025
I just replaced it and work very well.
Ki Mollison
Reviewed in the United States on February 17, 2025
great pump for the money
keyzmon
Reviewed in the United States on May 3, 2024
I bought the oil replaceable and there are no instructions included for this type of pump included. I installed the pump, filled with 85w90, primed it and started it up. It only reached 2000psi and when I pulled the trigger on the wand pressure dropped to 1000psi, not the 3400psi as advertised. I contacted their customer service to find out how to adjust the unloader but the picture and instructions I received was that of the thermal release valve. Here us what they sent:Thanks for your contact.To confirm the exact problem and provide you with the best solution, please provide the below information first.1. The brand and model number of your pressure washer;2. Please send us clear pictures of the pressure you measured when you release the trigger and pull the trigger;3. Please also help to send us clear pictures of the pump when it is installed with the pressure washer, and then take the pump off and send us some clear pictures of the pump inside;And here are the steps to adjust the pressure, you also can first try to adjust it to check if it can help to address the issue:Face to the Unloader ValveStep 1Small Nut (outside)Hold small nut with hex keyStep2Big Nut (Inside)rotate very little at 15 degrees：Counterclockwise it will reduce the pressure,Clockwise to increase pressure.Step3Small Nut (outside)Tight small nut touch bigger nut makes sure Big Nut is also tightened by spring.I also attach a picture for reference.Looking forward to your reply.Sincerely,LynSince there is no model number to be found anywhere and I bought a Yamatic from them why ask for the make, this is ridiculous. I have since been able to figure this out on my own and it seems to be working as it should. Only time will tell.
SKP
Reviewed in the United States on December 22, 2024
It appeared to be working fine, then after about 2 hours, it started loosing pressure for anywhere from a split second to several seconds. The sudden loss of pressure was instant and unpredictable. I contacted the seller who was very responsive. They had me go through a series of tests. Ultimately, I returned the pump and they sent a new one to me immediately. The new pump seems to be working fine. I haven't used it much, though.
Recommended Products
$94.99
$ 42 .99 $42.99