Your cart is empty.
Your cart is empty.
Features:
- Snap-in design allows for fast and easy installation.
- U-Hook design helps clamp tubing together, make the pipeline more tidy.
- Suitable for water supply pipeline system and cable wiring pipeline system.
- Mainly used to fix and tighten hoses and PVC.
- Also used for laying and installation of water, oil , PEX, etc.
Easy to Install:
The base of the clip has mounting holes.
You only need to use screws (not include) to fix the clip where you want.
Then put it into the retaining ring.
Recommended installation spacing is 24-30" for horizontal runs and 36-48" for vertical runs of tubing.
Customer
Reviewed in the United States on March 21, 2025
Gracias muy Bueno
Mark J Maloney
Reviewed in the United States on September 19, 2024
They do the job. Nothing else to say
Placeholder
Reviewed in the United States on August 21, 2024
I got these for the repiping of my trailer. Reason being that if I ever need to replace a section of pex, it’ll be easily performed. All that to say, I wanted something it could snap in and out of. These straps are great. They appear to hold the pipe in well enough when needed, and allow it to be removed easily enough.The fit was perfect. I can’t speak on the longevity of them.I didn’t look to see if they’re upc listed (because I didn’t need it for this project), so you’ll want to double check to make sure they can be used for a residential or commercial project.
D. Robinson
Reviewed in the United States on February 26, 2024
They’re pretty weak, but I guess they work as long as there is zero stress being put on them at all!
Jessee Ireson
Reviewed in the United States on October 30, 2024
Worked well with 1/2 “ pvc pipe
Average Joe 12
Reviewed in the United States on July 13, 2023
Conveniently packaged, fairly priced. Same brand at the local hardware (chain which begins with an "A") store but conveniently delivered to my porch (I was not in a hurry).Would buy again. Works fine in securing CPVC.
THanow
Reviewed in the United States on November 3, 2023
The description says these are good for 1/2" OD tubing. I think they mean 1/2" nominal diameter. Their diagram shows the ID of the clip to be 0.61", so 1/2" OD tubing (0.50) would be sloppy loose. I am sure it works fine with standard 1/2" Pex tubing which is 0.625" OD. So this won't work for my 1/2" OD tubing like I hoped.
Cr
Reviewed in the United States on November 17, 2023
The media could not be loaded.
Recommended Products
