Your cart is empty.
Your cart is empty. A quick, easy alternative to direct wiring when tapping the ?hot side? of the fuse block.
The blade type fuse tap is made of sturdy brass and is engineered for quick connect and disconnect of accessories such as C.B. radios, hand-held lights, etc. Installation can be completed in three steps.
1. Use a test probe to locate the ?hot side? of the circuit in the fuseblock. Then snap the tap over the corresponding ?hot side? blade of the fuse. Insert the fuse into the fuseblock.
2. Crimp one end of an in-line fuse holder (with the fuse installed) to a fully insulated nylon .250" female quick-connect terminal. Attach the other fuse holder lead to the accessory wire.
3. Complete the connection by sliding the female quick-connect terminal onto the protruding tab of the tap.
25 Per Package
WILL
Reviewed in the United States on August 15, 2024
They look good and should work great.
Customer
Reviewed in the United States on November 2, 2021
use these at work as we are required to add devices that require power. these help to quickly add the power required and ar they are eady to use.
kevin
Reviewed in the United States on May 26, 2020
Item was as described.
Steve
Reviewed in the United States on December 15, 2017
Eh. Won’t fit in the fuse box for 2013 Dodge Charger. I’m sure they work fine but didn’t work for what I needed.
PJ
Reviewed in the United States on April 29, 2015
No issues at all
Recommended Products
