Your cart is empty.
Your cart is empty.BZBMGMO 35MM Crowfoot Nut Wrench Opening,1/2" Drive Crowfoot Wrench
Kimberly Gallegos
Reviewed in the United States on August 27, 2024
What more is there to say? It's well made, worked great and was a great price! Was able to torque my barrel nut down to 50 ft/lbs with no issues. It didn't even leave any mars or marks on the wrench which tells me this is MUCH better quality than I thought. Thank you!
JC
Reviewed in the United States on December 26, 2024
Wilson Combat's AR10 barrel nut is listed as needing a 1-3/8" crowfoot wrench to torque it on, however no 1-3/8" wrenches were fitting (and I tried quite a few). Decided to try a 35mm and it fits tight, the listed torque rating on these are low at 35 ft-lbs but it held up just fine to the 45 ft-lbs pull that lined up the holes for the handguard properly.
James R
Reviewed in the United States on December 14, 2024
This wrench is as tough as a railroad spike while still being thin enough to work on my applications. An 18" breaker bar has yet to cause it to spring out of dimensional tolerance.
The Guy on the Couch
Reviewed in the United States on November 5, 2024
Fits and Works. Not sure what else to say. Mounted my wilson combat ar10 handguard without issue.
Eric
Reviewed in the United States on November 23, 2024
A lot of cheap crowfoot wrenches are to fat to fit on barrel nuts. This one is just the right thickness for this high profile ar10 handguard. This one was cheap, looks high quality, will perform its function perfectly, and should last forever. Just waiting on the barrel to show up.
Colby Carter
Reviewed in the United States on October 24, 2024
But if you’re ok with that it’s great. Worked for my Wilson Combat AR15 handguard. I’ll probably use it only 2-3 times ever so it’s totally fine.I’m a professional me h by trade and tbh the quality for this is perfectly fine for probably any application you will use it for.
Recommended Products
