Your cart is empty.
Your cart is empty.5 pack Brass Potentiometer Adapter Sleeves.
6mm inside diameter and 1/4 inch (6.35mm) outside diameter x 3/8 inch tall.
These are used to install set screw knobs that were designed for 1/4 inch solid shaft pots on split shaft pots (both fine and coarse splined) and metric 6mm solid shaft pots.
These will increase the diameter of the pot's shaft so the knob will sit centered on the shaft.
Michael Matyas
Reviewed in the United States on September 6, 2024
This part made light work of adding a pair of Guyker rainbow chrome control knobs to my guitar. I had replaced the bridge, tailpiece, tuners and pickup rings with Guyker rainbow chrome hardware. (I had trouble with the locking tuners and I mentioned that in my review of the Guyker hardware, but that has no bearing on the pot adapter sleeves.). The sleeves made it a breeze to mount the Guyker knobs onto my guitar’s metric sized pots. Project completed, and my $80 Lyon By Washburn solid body looks like an amazing custom instrument. Great way to fix knobs with setscrews onto imported guitars without replacing the original potentiometers. I would recommend these for this type of application and if needed I would buy them again.
Michael Adkins
Reviewed in the United States on May 7, 2024
Well, these were a complete waste of money. They must be made for a specific guitar because the knob would'nt go on. I even tried to tap it on but no go.
Joe V.
Reviewed in the United States on May 18, 2024
Work as advertised, used them on my Charvel Custom Shop after I had to replace the volume pot that died.
Recommended Products
