Your cart is empty.
Your cart is empty.TECHNICAL PARAMETERS
- 10 Functions: A,B,C,D,E,F,G,H,I,J
- Supply Terminals：A1-A2
- Voltage Range: AC/DC12V-240V,50-60Hz
- Burden: AC0.09-3VA/DC0.05-1.7W
- Power Input：AC max.6VA/1.9W
- Supply voltage tolerance: -15%; +10%
- Supply Indication: Green Led
- Time Range: 0.1s-10days,ON,OFF
- Time setting: Potentionmeter
- Time deviation: 10%-Mechanical setting
- Repeat accuracy:
- Temperature coefficient: 0.05%/°C,at=20°C(0.05%°F=at 68°F)
- Output: 2 x SPDT; Current Rating: 2 x 16a (AC1)
- Switching voltage: 250VAC/24VDC
- Min. breaking capacity DC: 500mW
- Output Indication: Red Led
- Mechanical Life: 1x10,000,000 cycles
- Electrical Life(AC1): 100,000 cycles
- Reset time: max.200ms
- Operating Temperature: -20°C ~ 55°C / -4°F ~ 131°F
- Storage Temperature: -35°C ~ 75°C / -22°F ~ 167°F
- Protection Degree: IP20
- Overvoltage cathegory: III
- Pollution degree：2
- Installation: DIN rail mounting or Screw mounting
- Max.cable (size): Solid wire max.1x2.5 or 2x1.5/with sleeve max. 1x2.5(AWG12)
FUNCTION FEATURES
- 10 Functions: ⑤ time functions controlled by supply voltage, ④ time functions controlled by control inport,① function of latching relay
- Comfortable and well-arranged function and time-range setting by rotary switches.
- Relay status is indicated by LED: Green for Power indicator, Red for Output indicator.
- 1-MODULE,DIN rail mounting. Ultra-small size, only 18mm width, mounted with 35mm DIN Rail .
WIDELY APPLICATION
- The multifunction time relay can be used for electrical appliances,control of lights,heating,motors,pumps and fans
M. Adam Davis
Reviewed in the United States on July 13, 2024
I’m using this to add hysteresis to an automatic transfer switch that switches a subpanel of my house from utility to the off grid solar system.There are certain situations where it would switch to solar, overload the inverter and switch back, and this would happen dozens of times a second until the inverter turned off or I caught it. We’ve had to micromanage the transfer switch ourselves since then and reduce the loads in the subpanel, but with this I can at least guarantee it won’t switch more frequently than every 10 minutes, preferring the utility side. Since the microwave, toaster, and air fryer were often the feather that broke the camels back this is enough time to prevent it from switching too often, and ten minutes of sun charging the batteries with no load also gives the solar system a chance to catch up.
Gopiballava
Reviewed in the United States on April 27, 2024
This device seems to usually behave correctly. However, mode F sometimes does not work the way that it's supposed to.Mode F is supposed to stay on for a fixed time. If you have the time set to 5 seconds, and trigger it for 1 second, it should stay on for the full five seconds.Sometimes, when you switch to mode F, it doesn't do that. If you apply the trigger for 1 second, it only stays on for 1 second.So far, it's never done that if you power it on in mode F. But I haven't tested it extensively; it might do that some of the time as well. It's definitely concerning to me, because the reason I want to use this is because I have hardware that can get damaged if you power cycle it too quickly.
Recommended Products
