Your cart is empty.
Your cart is empty.Here's ultimate clear bass satisfaction guaranteed! Smash amplifiers from Crunch can fit in any small space while remaining cool. This Smash 1,100 Watt 2 Channel Class AB Amp features a heat sink that keeps the amplifiers from overheating and a power supply that delivers power with minimal impact on the electrical system, embrace the highest sound quality connection with RCA materials that help prevent interference and minimize distortion. Anywhere the adventure leads to, Smash will be there for your audio.
coop
Reviewed in the United States on April 19, 2024
Easy to install
John Warnock
Reviewed in Canada on March 1, 2023
False advertising. Amp is rated supposedly at 1100watt rms.. tested anp and at full power only hit 286watts rms.. full junk amp and full lieing by seller.. never again will I buy a crunch garbage amp...
francisco salgado
Reviewed in Mexico on August 17, 2022
Muy buena marca buen desempeno a pesar del tamano fisico
Da Baby
Reviewed in the United States on June 7, 2022
Wasn't sure if it was gonna be good because the price but went ahead to test it out from the reviews and it works perfect with my 2 500w 4ohms 10's and sounds pretty decent and WORKS!!
Shane Putman
Reviewed in the United States on May 15, 2022
Only stays on for 60 seconds and shuts down highly disappointed with crunch
Zakia Lee
Reviewed in the United States on March 17, 2022
This Amp works like wonders, has a nice safety feature where the amp goes into a overdraw protection state. turns out my battery dips under 12 volts sometimes since my volt meter is ran off my alternator.Bumps both of my 8's pretty well so far.EDIT: after installing a Capacitor and changing out for thicker gauge wiring, Amp runs a lot cooler and bumps a lot harder. The problem is that after 75% gain, and songs that contains heavy bass kicks cause the amp to go into protection mode.
Adam
Reviewed in the United States on December 10, 2022
The red wire is the 12v the thin blue is the REM. As you can see they are swapped. Meaning 1 of two things. 1. They are labeled wrong or 2. The inner components are swapped. No matter how you look at it, it's a factory defect. If you have issues with your amp losing power, swap your REM and 12v, then make sure that you sun the system for a while. Assuming it worked and ran for a while and the wire don't get hot. Your good to go. This should really be looked into. I can provide future evidence if necessary.
Misfit13
Reviewed in the United States on November 28, 2022
Crunch used to be alot better about thur ratings but i also knew i wasnt getting 1k watts just looking for cheap replacement to hold me over, it does MAYBE 3-400 watts and is not two ohm stable and can not be bridged for a big sub that draws actual power, im running skar evl 10 d2 i turned the bass boost all the way down and put it back too one channel to work ok, if just for speakers it will do very well
Antonio
Reviewed in the United States on November 23, 2021
Works great.
Noelani808
Reviewed in the United States on October 2, 2021
Perfect for exactly what we needed it for and great price
Recommended Products
