Your cart is empty.
Your cart is empty.CURT 11487 Class 1 Trailer Hitch, 1-1/4-Inch Receiver, Fits Select Scion xB
Adrian Ramirez
Reviewed in the United States on February 24, 2024
Bolt on hitch comes with hardware easy to install the hardest part is lowering the exhaust a lil to be able to bolt on the left side
Santino Raimondi
Reviewed in the United States on December 7, 2023
Worked Great with 2006 Scion xB. easy install. Was slightly bent and has to twit a little but I have had this issue with every hitch I have ever installed.
A. Product Reviewer
Reviewed in the United States on February 10, 2021
Holes didn’t line up well, but that’s pretty normal for a trailer hitch. Use a spreading clamp to force the alignment into place while you drive the bolts in and it goes well enough. I was able to assemble it without lowering the exhaust, but I did have the back of the car up on ramps, and that helped. Brackets for the bumper skirt seemed out of place, but the final result looks good from behind the car.It will scrape occasionally depending on the driveway where I never had issues with scraping before... but it does hang down an extra 1.5” or more. A two place bike rack goes nicely into the receiver.It makes me think about getting air bags for when I have people and stuff in the back causing some extra sag.
leslie harper
Reviewed in the United States on May 9, 2020
It took a few blows with a sledge to get it to fit. Was 1/2 inch off. Did not have bolts. The M10-1.25 Bolts in molly were hard to find, so I went to junk yard and pulled some off junk cars. Rides a little low. Pulls well, stayed tight. This was the 3ed one. They sent one that pointed down instead of back, one made for something else, that I could have drilled 4 holes and got it to fit and this one. This is a small car and not intended to pull much. After a hitch broke off a hitch near Area 51, I always use molly. They are about 4x as strong as 6 tick.
Brian Motta
Reviewed in the United States on May 19, 2020
Good quality hitch however holes do not line up once you install one side. Had to remove it, secure and bang it with a mallet several times in order to get a little flex for holes to line up. A little tricking getting around exhaust side of vehicle. If have an aftermarket exhaust tip or extension remove first before trying to install.
Suzie Hardt
Reviewed in the United States on December 31, 2020
I cannot use the item because it was bent. It was sold bent and no information was included. I will not return it because. I want to try and heat it up and bend it back and use it. I should get a refund and an apology. Again the box was not damaged. This item had been returned and the vendor sold it and shipped it out disregarding the bend that makes it unusable.
Roger
Reviewed in the United States on January 30, 2020
I installed the receiver on my Scion XB so I could connect a carrier for two e-bikes. The fit was perfect. It was a little tricky temporarily removing a muffler hanger, but it was fine. The manual specifies 48 foot pounds for the bolts, so you'll want to use a torque wrench.
Flashclip
Reviewed in the United States on September 17, 2016
Works as expected, put it on a 2005 scion xb without too many issues. Was worried a little about making that poor little car pop a wheelie with this extra weight in the back but no such misfortune yet, even with it loaded down with bikes. I will say, even when unloaded it scrapes on particularly steep driveways but it seems to take the hit just fine.
Recommended Products
$197.99
$ 78 .99 $78.99
$54.99
$ 25 .99 $25.99