Your cart is empty.
Your cart is empty.
EA-550 Industrial Sewing Machine Brushless Electric Servo Motor With Needle positioner.
Energy Efficient - Saves up to 70% Electricity. 3/4HP, 550 Watts Powerful Heavy-Duty electric servo motor for any type of industrial sewing machines for light to heavy duty work including straight stitch machines, overlocks, zigzag stitching machines, blindstitch machines, heavy duty walking foot and heavy duty upholstery machines.
Uses the same mounting holes as a clutch motor
No noise or vibration when machine is not running
Draws minimal electricity when machine is not running
Includes needle positioner (Synchronizer), motor will run with or without the synchronizer
High Torque D.C. Electronic Servo Motor
Easy to adjust speed & motor direction with buttons
No clutch disc
Adjustable belt tightener
Belt guards, pulley & mounting hardware included
Light weight Approx. 10-12 lbs. (5 kgs)
Starts-up at low speed
Works well on heavy duty machines
Speed 0 - 4,200 RPM
110 Volt, 3/4HP, 550 Watts, 50/60hz
J. G.
Reviewed in the United States on March 16, 2025
Instructions are not existent. Took way too long to get the needle positioner working. Then it didn’t work. Now its working again. I dont have a lot of confidence in this so far. It might be ok?
CRS
Reviewed in the United States on September 12, 2024
I needed a longer belt than what came stock with my machine, but after getting that I couldn’t be happier with this motor, vfd and needle positioner.
Allen Hutchins
Reviewed in the United States on July 31, 2024
Worse servo i have ever bought. Everything about it was defective
SewJude
Reviewed in the United States on February 22, 2024
I'm a 66 year old woman and I was able to install this with no problem. I installed this on my 950 Bernina which is a semi-industrial. The needle stop did not fit this machine.I am very pleased with this especially over the clutch motor!
David H.
Reviewed in the United States on November 30, 2024
Operates the machine as if it is new and customer service was excellent.
Steve Jung
Reviewed in the United States on August 24, 2023
This setup works as I expected it to, I already had a servo motor however, I wanted the needle positioner so I was forced to upgrade. There are only a couple of things I am not happy with, first thing is that the belt guard was not really designed that well as you can see by the picture. It is very limited. I wish it come with a half circle guard like my previous Consew servo motor had because then I could actually use it and they are not interchangeable. The second thing is that this motor is very loud compared to my previous one. The motor I had on here before was almost silent and they are the same ratings as far as torque. Other than that it seems like a great product so far and it was very simple to install. Only took about an hour from start to finish.
MW3
Reviewed in the United States on September 28, 2022
Great product! Using it on a Juki 1541s and it sews two pieces of 5oz leather together with ease! Lots of power, and quiet! If you plan to use the needle position sensor you must use the 75mm pulley that comes with it. I had a smaller pulley that I wanted to use, but found out that’s why the needle position sensor wasn’t working properly. Switched back to the 75mm and it worked!
Al Blount
Reviewed in the United States on September 25, 2021
work great. Can now do one stich at a time.Control of speed is so nice
Recommended Products
