Your cart is empty.
Your cart is empty.Dell YT39Y Poweredge R620 R720 R820 1100W Power Supply
PharoShep@aol.com
Reviewed in the United States on April 28, 2025
this item will not function in the server which it was meant for. Both power units are the same voltage, size, everthing by the same vendor and it it not recognized in either power bank. I would say that it's the server but the original power unit works in both banks. Even had Dell send me another one and it does the same thing.
Kendrick
Reviewed in the United States on July 12, 2024
This was a well packaged referb part worked as expected. The only down side is the description could be improved by stating its the older part not a new style EPP version.
carmen
Reviewed in the United States on March 3, 2024
Very good quality. Puts out clean 12VDC 91.1Amp power. Great for diy power supply with better specs than more expensive types.To turn on all the time, connect pins*:13 and 14 to each other (solder blob)Then (13-14) to (16)To use a SPST switch to turn it on/off:(13-14) (solder blob) to one terminal of the switch(16) on the other terminal of the switch*Pins are on the bottom (non-label) side.13-14 are the right most pins on the bottom. 16 is the 4th in from the right on the bottom.The main power output pads looking at the top side are:(+) is the left large pad. (-) is the right large pad.
alex rudy
Reviewed in the United States on February 23, 2024
Using as a high amp bench 12v supply (instructions below). As other reviews mention, it’s hackable, but the info can take some digging to find. Fan only runs as needed, for my uses (up to 30a continuous) it’s rarely above idle. It will rev up like a jet engine when first powered up, but quickly slows back down. 80plus platinum makes a big difference I guess lol.To power on the supply, place it on a bench with the label down and connector near the top (ignore the label if unsure and go by connector position). In this orientation, the 2 small tabs closest to the end of the connector are what you need. Solder them together, and run a little jumper wire to ground (add a power switch to this wire if desired). The big (power) tabs are as follows, starting from the one closest to the little tabs: 12vsb (low power, generally not used for DIY), ground, ground, 12v, 12v. These tabs are connected directly to the matching tabs on the other side of the connector, the little ones are not.
Tim G
Reviewed in the United States on November 12, 2023
with a couple resistors this can be turned into a hobby power supply. lots of power small price.
Fizzybubbly
Reviewed in the United States on October 27, 2023
great value , bought two. both work perfectly . will buy from again .
fafa
Reviewed in Canada on January 29, 2022
Waste of money.
AviGA
Reviewed in the United States on November 5, 2021
My customer service experience very poor and not helpful at all. I believe product is good, but I would buy the product somewhere else where can get much better customer service.
MusicInside
Reviewed in the United States on November 12, 2021
Works fine, recognized by iDRAC. Good price.
Recommended Products
$25.99
$ 11 .99 $11.99
$139.99
$ 61 .99 $61.99