Your cart is empty.
Your cart is empty.This replacement engine coolant thermostat housing is engineered to match the fit and durability of the stock thermostat housing on specified vehicles. It is designed to withstand extreme temperature changes to extend service life. Vehicle model years this part fits (be sure to check your vehicle trim using the Amazon garage) - [Ford Ranger: 1992, 1993, 1994]
Jorge
Reviewed in Mexico on February 17, 2025
The media could not be loaded.
Wesley
Reviewed in the United States on January 5, 2025
Will not hold thermostat
Michele Hartle
Reviewed in the United States on January 30, 2025
actually better than factory. 100 % quality!
BBSnipe
Reviewed in the United States on January 20, 2025
Product fit perfectly. Getting the clamps off of my 94 was a wrestling match! Thermostat bolts are hard to access.
Anthony carver
Reviewed in the United States on January 19, 2025
The media could not be loaded.
V. Richie
Reviewed in the United States on July 27, 2024
Yes, it's for a Ford 2.3 Lima. Yes, it is the right part. No, it doesn't fit because doorman apparently either has no jigs, or they never even bothered test-fitting these things. The heater core feed line interferes with the timing belt cover, so you get a choice: no coolant neck, or no timing belt cover. So now what do I do? I waited for this to arrive, and now I'm STILL down. Thanks Doorman, I know what aftermarket to avoid now. All I can hope for is to get out the torch and hammer and see if I can make it fit, and Doorman should be paying ME to fix their junk.
Eugene Moody
Reviewed in the United States on April 21, 2024
Very durable.
Takeo_San
Reviewed in the United States on July 25, 2023
The old one on my 2.3L was rusted through and leaking. Replaced it with this one. No more leaks, very happy.
David
Reviewed in the United States on May 14, 2023
The one Amazon says fits my truck, does not. Amazon says this one does not fit but, it does.*However, it does not fit perfectly. Both hose barbs are slightly bigger then the OEM ones. The upper radiator hose barb is 1/8" larger in diamter. The hoses go on with only a little extra effort but the spring clamps will not expand far enough to slide into place.*There is a small tab on the spring clamp (see pic) you can bend down so the clamp can be expanded far enough to slide back into place.*Do not replace these spring clamps with screw type hose clamps. The spring clamps work much better as they keep a constant tension even as the rubber hoses shrink with age.
Recommended Products
$35.78
$ 17 .99 $17.99