Your cart is empty.
Your cart is empty.
This single 120V/230V Single Phase On/Off Switch is intended to provide you with a high quality safeguarding component for your workshop and power tool needs.
Specifications Type:
Single Phase On/Off Switch with Deep Switch Box Hardware
Operation Mode:
Start Stop Push Button ON-OFF-ON
Dual Voltage:
110V/220V
Rated current:
2 HP/35 amps at 120 volts | 3 HP/20 amps at 230 volts
Application Equipment:
Table Saws, Router Table, Drill Press Band, Saw Sanders and Jointers Dust, Collection Systems for Woodworking
For added safety measures, the start button can be locked to prevent unauthorized use. (Please Note: The switch is built with heavy duty electrical components and a force range of 40-60 Newtons or 9 to 13.5 pounds force is required to activate)
warren maziol
Reviewed in the United States on January 27, 2025
The box is not deep enough for the switch to fit in it!
Master
Reviewed in the United States on January 14, 2025
I used this switch to install a safety shut-off on a shop-built router table and it works well. I’d prefer it if the Stop switch were a big paddle but, nonetheless, it still works.The problem I ran to, however, was tightening down the wire screws. It seems that they thread into only plastic and it seems I went a smidge too far and stripped the threads. I had to fall back and solder the wires in place. Still works, but was a hassle dealing with that.It’s a useful switch, but not the greatest quality.
DFL
Reviewed in the United States on January 12, 2025
This was ordered to replace a cheap switch on an old 1 HP 14" bandsaw. I've installed a few of these switches and they're rated for a lot more than 10 amps as was described in the listing. I thought it was probably a typo and ordered it. When it arrived I checked the the label on the switch and it shows that it's rated for 2 HP at 120 vac, a lot more than 10 amps. What I found was that the cord connectors are so small that you can't get more than an 18 awg cord through the connectors, which is rated for 10 amps. The design of the box is such that you can't fit a larger connector in either.I ended up tossing the j-box and mounted it in a deep box with an extension. It was an added expense, but the switch was useless to me otherwise.If you have an application using 18/3 cord it'll work, but for anything more than 10 amps get something else.
biomedman
Reviewed in the United States on April 12, 2025
Very tight fit for wire 14awg or more. Made for 16awg. No ground connection. No wiring instructions included. Not made for good wire connection.
Recommended Products
