Your cart is empty.
Your cart is empty.Festoon 491666 Cutter edge trimming HW D19/16.
Markus Gasteiner
Reviewed in Germany on June 20, 2023
Der Fräser wird bei mir in er OFK 700 verwendet. funktioniert einwandfrei. Preislich ist Festool natürlich etwas höher angesiedelt. Standzeit ist gut.
Lisa
Reviewed in Germany on June 9, 2021
Sehr gutes Produkt. Leider stehen bei Amazon falsche Maße. Der Fräser hat 15 mm statt 16 mm Schneidenlänge.
Manuel F.
Reviewed in the United States on December 25, 2020
I am using it to trim plastic laminate edge strips and it leaves a very close to top cut that requires little or not sanding. It also outlives other cutters I have used before for the same task.
Customer
Reviewed in the United States on July 14, 2019
This is the only bit that works in the Festool trimmer. Makes using the mfk700 a breeze.
A.S.
Reviewed in the United States on June 24, 2019
It is expensive, but is a really nice bit. I have been using it to trim 1/4” maple edging on both sides of 3/4” plywood. I have just finished 30 sheets of plywood, cut into 1 foot wide boards. That works out to 1920 feet of edging.I couldn’t be more pleased with the results.
maurizio lodesani
Reviewed in Italy on November 14, 2018
ottima fresa per il rifilatore OFK 700, dimensioni perfette, tagliente con angolo particolare, in modo che dopo l'affilatura non cambi il raggio.Per me Festool è sempre una garanzia
Louis
Reviewed in Canada on May 31, 2017
Top quality, festool is more expensive but it's worth it. I am a satisfied customer.
alekezam
Reviewed in Canada on April 20, 2016
excellent quality but it should be for the price.
Jose M. Lona
Reviewed in the United States on April 13, 2016
seems little big for the trimming router.
ChuckT
Reviewed in the United States on February 11, 2015
Fantastic router bit for trim routing.
John J.
Reviewed in the United States on July 28, 2014
This is the only bit that works with the MFK 700 Trim Router to trim edge banding. When using the router in the horizontal position and the guide bearing, this bit will fit and allow the user to get the 1.5 degree bevel the trim router is set up to make. I have used this bit to trim both plastic laminate (Formica) and birch wood edge banding. When properly adjusted, the bit gives a beautiful edge and the 1.5 degree is hard to see but keeps folks from catching the edge banding.My only complaint is that this bit is not provided with the trim router.
Elswee Vazquez
Reviewed in the United States on December 15, 2014
I began testing just a sanding block, now all my tools are Festool..... The best.....
EvenMax
Reviewed in the United States on January 1, 2014
This is the bit I needed to trim with the Horizontal base on my MFK 700 Trim Router. Works perfectly.
Recommended Products
$24.95
$ 11 .99 $11.99