Your cart is empty.
Your cart is empty.Product Description
1-1/8" (Dia.) T-Slotting Cutter Bit
From the Manufacturer
Build your own display with Freud's T slotting cutters. This is an easy way to have a sturdy, attractive display without a lot of cost. Covered by Freud's limited lifetime warranty.
BJ engineer
Reviewed in the United States on April 5, 2025
bit performs well in hardwood
Daryl L. Lavway
Reviewed in the United States on March 21, 2024
Like how accurate it is; I use it in my hobby woodworking shop
Keven Robin
Reviewed in Canada on February 15, 2024
As expected!
Flytheater
Reviewed in the United States on December 17, 2024
Great overall bit. Saved money by making my own slat panels for my garage wall. Not much else but good strong and reliable.
Phil Wood
Reviewed in Australia on December 10, 2024
Perfect tool for the job
Boogie
Reviewed in the United States on February 15, 2023
If you are looking for a bit to make slatwall this is it. Since slatwall went to $250 a sheet I decided to try this and it's perfect for making slatwall. Super sharp.
labrecque michel
Reviewed in Canada on February 20, 2021
Ok
Peter Leidich Jr.
Reviewed in the United States on December 15, 2016
what I needed to finish my project.
mike
Reviewed in the United States on August 2, 2015
Freud bits are about the best
Celso Luiz G. Silingardi
Reviewed in the United States on November 16, 2015
100% satisfaction
Ethan A. Hunt
Reviewed in the United States on July 9, 2013
I bought this to make a jig to cut 4 inch dovetail joints on a large board. Mounted in my router table (using the Bosch 1617 EVS), the bit easily cut a t-slot 24 inches long in a 2x4. Then it was a $4 trip to the hardware store to get carriage bolts and wing nuts (make sure the bolts have a square shoulder large enough to catch in the slot so the bolt doesn't turn). Voila!
Recommended Products
$24.95
$ 11 .99 $11.99