Your cart is empty.
Your cart is empty.Product Description
PUNCH, DIE, DRAW STUD CONTENTS; 10 GAUGE MILD STEEL CAPACITY; 1. 28 INCH HOLE SIZE; ROUND PUNCH TYPE; SLUG-BUSTER[R] BRAND; APPLICATION PUNCH MILD STEEL, ALUMINUM, FIBERGLASS, PLASTIC; USED ON BATTERY-POWERED/HYDRAULIC/RATCHET/MANUAL DRIVER
From the Manufacturer
Greenlee Slug-Busters can be used on mild steel up through 10 gauge (3.5 mm). Application: Punch mild steel, aluminum, fiberglass and plastic. Operates with battery, hydraulic, ratchet or manual drivers.
Ben D.
Reviewed in the United States on January 3, 2024
I have used several different brands of hydraulic and mechanical knockouts over the years and these hands down are the best! Hardened shaft and cup. large top bolt and thrust bearing make these a stand out. Take good care and oil them before use and they should last for years.
Tenther1
Reviewed in the United States on May 2, 2016
I had to punch some holes in 16 gauge sheet metal. I had 3/4" pipe with a 3/4" to 1/2" female adaptor. The hex that had to go through the holes was as close to I.280" as possible. The pipes just cleared. The slug -splitting feature is most welcome; there is no need to pry or pull off the slug as in the past. The ball bearing attached to the draw stud makes the wrench turning go very smoothly.
Recommended Products
$147.61
$ 63 .99 $63.99
$75.99
$ 36 .99 $36.99