Your cart is empty.
Your cart is empty.Product Description
None
Reviewed in the United States on March 19, 2025
Would not stay on my hood. I think they should use a different wider tape
Dave
Reviewed in the United States on February 6, 2025
Update 4/6/25The adhesive has failed in the very center and it now has a raised ridge in the middle. It looks like it could be intentional and works to help with water run off. I tried to re secure it with silicone and also with double sided tape. Both did not work. This could be from normal stretching or the product relaxing over time.Original review belowAfter reading the other reviews here about gaps and fitment issues, I did the reverse roll as suggested to flatten it out more from its state it shipped in. Installed mine in cold weather and rain, cleaned and dried the surface before installation. Use a heat gun to warm up the surface as well as the material itself while working the edges down and making sure the double-sided tape adhered properly. No gaps as reported by other reviews, just make sure you line up everything and work middle out once centered. Peeling some of the adhesive on each end to hold in place and repositioning as needed once you get close to the edges.If I have any issues with longevity this review will be updated.
Mike P.
Reviewed in the United States on January 25, 2025
It does seem to be just a tad bit longer than the hood, I found off you lay it out for a short time and then lay it on your hood in the sun without sticking down it will lay out and form to the hood better before. Make sure you clean the paint with a cleaner that will clean the wax or polish off it does not stick good on wax or polish.
RazorBacker
Reviewed in the United States on January 15, 2025
It's looks to fit well on my 2022 f150 stx but it shows gaps along the bottom as it flares up words the side of the hood.
Barry F.
Reviewed in Canada on January 13, 2025
I like the looks of it after I uncoiled it and warmed it up and flattened it, but have not installed it yet, so can't comment on the finished product.
Billey Evans
Reviewed in the United States on April 14, 2025
Great product would suggest letting it set in the sun for a lil bit while it is unraveled before putting it on. But great looking and durable.
Ramon Rodriguez
Reviewed in the United States on December 28, 2024
Looks great, fits great.
Mack
Reviewed in the United States on December 23, 2024
Product was not what it appeared , it is a piece of rubber not a moulded hood protector
J shep
Reviewed in the United States on November 7, 2024
Fits perfectly on 2024 f150.It looks great and it’s made of a solid thick rubber .Highly recommended 👍
Recommended Products