Your cart is empty.
Your cart is empty.Clean home theater set-ups (especially set-ups with wall-mounted HD TVs) can require you to store your video equipment (like Blu-Ray players, DVD players, TIVOs, etc.) in a remote place like a closet or another room. Since your remote controls require line-of-sight to control your equipment, you won't be able to use them unless you can send the remote signal which is an infrared (or IR) signal to your equipment with a wired extender. This IR Receiver is used in tandem with the Blast IR Classic. The receiver is mounted on a keystone wall plate near your tv. If you're starting from square one, check out our IR Reciever Kits.
Jeff
Reviewed in the United States on May 27, 2023
This thing doesn’t fit in a Legrand keystone insert or a Leviton QuickPort… sending it back, regrettably.
Sandia Sunset
Reviewed in the United States on April 12, 2023
Doesn’t fit normal keystone plate
Goldenpiggy
Reviewed in the United States on January 1, 2021
This keystone jack IR receiver works flawlessly with a dual-band control unit that has 12V power supply (doesn't have to be Sewell's BlastIR.) It allows you to have a professional-looking installation when you run a CAT5e or CAT6 cable in the wall or ceiling to the control unit -- no dangling cables, double-sided tape, etc. I like that it has a blue LED which lights up when it receives the IR signal from a remote control.The only minor issue I had was I could not get it to positively click into the keystone slot on two different-brand keystone blanks. Nothing that a utility knife can't fix.Highly recommended.
Recommended Products
