Your cart is empty.
Your cart is empty.PanaVise is a major manufacture of Vises and Work Holding Tools. PanaVise's Tilt, Turn & Rotate technology has been applied to the product line, allowing for maximum efficiency and many different uses! All PanaVise Products are covered by a Limited Lifetime Warranty! Introducing the Panavise 343 NYLON JAWS (pair) for 301, 303, 304 and 381 w/screws, Perfect for small tubes, rods or circuit boards! Standard replacement Jaws for our 303 and 304 Vise Heads. Type 6/6 Nylon Jaws for jobs requiring electrical insulation and gentle holding power. Continuous heat tolerance to 200 F (93 C), intermittent heat to 300 F (149 C). Limited Lifetime Warranty!
Kat
Reviewed in the United States on June 22, 2024
These grooved jaws are.......fine.......I guess. The Panavise is not a particularly precise tool but these jaws are softer than the original Nylon jaws, the holes are oversize so as to give ~1/16 movement around the screws, they have waves and ejector pin marks on their face, and the groove is so tiny as to be nearly worthless for locating a part.Better than my old chewed-up Nylon jaws but I don't expect these can survive any serious clamping.
R. Robinson
Reviewed in the United States on March 22, 2024
Groove is too small and not even. Not functional at all.
W.K. Gauger
Reviewed in the United States on December 1, 2023
These are nylon and resistant to abrasion they hold up to filing tasks in the vise.
Paul
Reviewed in the United States on October 1, 2022
We had our PanaVise for many years and the jaws were pretty bad. These replacement jaws work just like the originals. I would recommend this product.
Graywolf
Reviewed in the United States on August 23, 2020
Just like anything made by this company, it is top quality all the way.
Customer
Reviewed in Canada on August 19, 2016
just the job as described
Salty Donkey
Reviewed in the United States on January 27, 2015
Perfect for my panavise. I use these when coping baseboard trim and they don't damage the finished surface. The panavise can come right in the room with me and swivels to hold long pieces resting on the ground.
Colorist
Reviewed in the United States on March 29, 2013
These jaws are replacements for a pair that have 20 years of service. They are perfect and allow me to work fast again.
GD from ND
Reviewed in the United States on December 31, 2013
My old jaw pads were all melted and nasty from soldering iron heat and it was time to replace them. I could have bought the TFE jaws but I don't solder much anymore so these are great. Fit like original and includes new screws.
Recommended Products
$278.98
$ 99 .00 $99.00
$359.99
$ 99 .00 $99.00