Your cart is empty.
Your cart is empty.Jim S.
Reviewed in the United States on May 3, 2025
This kit makes sighting in much easier and covers everything up to 12 gauge bore. There are 32 adapters, batteries, small Phillips screw driver and an applicator tool for the smaller gauges. This all comes in a nice plastic, lightweight case with foam insert and cutouts for each adapter and the tools needed. The instructions are very thorough and complete. This will save you a ton of time and get everything very accurate.
Dan
Reviewed in the United States on May 1, 2025
This bore sight laser saves so much time compared to the traditional way. Simply find the adapter that fits your barrel (there are 32 so you should find one), install the battery in the laser, insert the laser into the barrel, and turn on the laser. From there, zero as you normally would. The laser is easy to see in full sun. The laser uses a CR2 battery; I carry the extra battery just in case - I was able to confirm zero on several items without the need to use the extra battery.
Tim McKenzie
Reviewed in the United States on March 25, 2025
I think key to this is that it's a budget friendly way to shortcut your efforts to dial in your rifles/etc. It's not perfect... but it's friendly on the budget and certainly gets you to the point where you can finish the job the right way.I like that it includes such a range of sizes... especially the smaller ones since I primarily got this to teach my kid how to zero the scope on his airsoft rifle. Can always use the larger ones on my rifle whenever I swap scopes too. Kudos to them for also providing a spare battery. That's always a nice extra! The case itself is great to have, but not one you want to knock around too much I think.The adapters themselves are plastic... which is a good thing because you don't want to scratch up your bore. They get a decently tight fit, even if it's not perfect. Properly fitted they hold it secure enough to get you on paper, where you can then bring things in to a proper zero. For me a bore sight is really just to shortcut the effort to get on the paper so that's good enough for me.
Shane
Reviewed in the United States on April 3, 2025
I have had three different brands of these now. This is my fourth and I think this is a winner. The first one the sharp crown cut through the thin aluminum steam. My second one had built-in batteries and the battery went bad with no way to replace it. The third one you could turn and the dot and it would travel in a four-foot circle. It was nowhere close to center. This one seems to have a good thick steam. It has replaceable batteries and when I spin it, the dot stays in the center. This one is already spot on and no calibration needed. Out of four different brands so far, this one is the best in many ways. It also comes with enough adapters to fit just about every caliber there is. Also, this one comes with two batteries, so it should last me for many years. I'm very happy with this one.
asta coakley
Reviewed in the United States on April 21, 2025
Neat little set, the cheap case is a little bit aggravating cuz the clips constantly want to fall off of it, when they're not latched. So usually when you put it up, you have to like pop the latch or two back on. But it's easy to set up. Easy to use. Pretty self-explanatory, and works nice,! Really good price. These things used to be so expensive
Russell M
Reviewed in the United States on April 13, 2025
This sighting system is a must have for any humter or target shooter. It's easy to use and set up, it's built very well and the brightness can be seen at 500 yards through the scope. Once centered and seated in the bore it's very accurate and stable. Definitely a great tool to have around for setting sights or scopes and not waste ammo.
Magnificent K
Reviewed in the United States on April 11, 2025
Got this kit to help zero optics on optics ready pistols and while it's ok for getting in the neighborhood, there are significant problems. For one, the labelling of the barrel inserts is incredbly hard to read and doesn't match the instructions. I am only using 9mm pistols and had to go two sizes down from what was recommended & what the diameter of a barrel actually is. Second, this isn't a precision kit and the price reflects that, so temper your expectations. You can make the laser dot shift by putting pressure on the emitter or by rotating. It's good enough, however, to get your red dot in the right area at 10 or so yards so that you can get on paper and then further lock down your zero when firing at the range.
Hickory Briars
Reviewed in the United States on April 1, 2025
I bought this to site in my new 9mm. The hardware itself seems to work well, although I had a hard time figuring out which adapter to use. The adapters are labeled in inches and do not have a mm conversion so I had to convert it myself. I still ended up using a size two sizes smaller than what my conversion was. This makes me winder if the fit was good enough and if my siting in was correct. Time will tell, hopefully I can get out and test it soon and will report back on how close it was.
Recommended Products