Your cart is empty.
Your cart is empty.Radar Mount’s Mirror Wire power cord quickly powers your device in minutes, using the existing connector on your car’s powered rearview mirror. Built using the finest BN sourced connectors with stress relief boots and fine mesh looming, don’t settle for less when it comes to powering your device. Radar Mount Mirror Wire power cords are compatible with most vehicles with a powered rearview mirror and install in minutes!
ed
Reviewed in the United States on February 7, 2025
unfortunately my return window has closed and I just got around to installing it. sometimes it works sometimes it doesn't. the radar works fine plugged in so I'm assuming the wire or the jack are interrupted somewhere. I also have a dash cam on the same pair of wires so I know there's constant power on the source wires.
Customer
Reviewed in the United States on January 23, 2025
Worked great for my 2022 Camry xse. The install was quick and easy. I used the smaller connectors pins to connect into mirror wiring.
Jake
Reviewed in the United States on April 18, 2025
Works perfectly! Just what I needed for my radar detector. Just push the prongs into the backside of the connectors for power and ground and its installed! I needed to connect the small included connectors to it for them to fit into my terminals. Turns on and off with my truck now too!
Martin Brault
Reviewed in Canada on July 23, 2023
This was very easy to install. Works great. Took about 15 mins to install from start to finish.
Eric
Reviewed in Canada on May 17, 2022
Just installed in my 2014 BMW 435i. Was super easy. Just stuck the little pins in beside the pink (positive) and black/brown (negative) wires coming out of the existing connector. It’s a little expensive for a short little cable, but still happy I did it because direct wire is much cleaner.
Customer
Reviewed in Canada on December 1, 2020
The clips that connect are cheap and don’t stay in. I ended up having to electrical tape the connections together to make them stay in place. Would t recommend this product for the price and for how long the shipping takes.
ianScott
Reviewed in the United States on May 5, 2019
Clean, convenient wiring harness install. A bit pricey but if you want the perfect solution without having to run a wire along the windshield to the fuse box, this is it and it's well made.***Word of Advice: Be sure that your radar detector is thoroughly secured to your windshield - I had my radar detector mounted via its factory suction cups but I drove up to a ski resort and during the day while I was there, my car got much colder than it was in Denver and the suction cups failed, so the radar detector fell and tore this wiring harness out and ripped the cable apart. Apparently the inline fuses are one-directional and I could have tried to disassemble the cable and solder/tape everything back together but I just decided to use a 3M Command Strip to semi-permanently secure my radar detector to the windshield and then I bought another one of these harnesses once I knew the radar detector couldn't possibly fall down again.
Customer
Reviewed in the United States on September 6, 2017
This worked great and the length was good too. Ok first the protective black nylon type braid around the cord is loose so it will come out of the plastic jack end so if you are pulling on the cord itself yes it can damage the jack or cause the wires to come out of the jack. Not a big issue. I took some Gorilla glue pulled the black nylon braid covering back dabbed a bit of glue in there pushed the covering in and then a dab or 2 around the covering and the inside edge of the jack itself. This sealed the nylon braid and secured it in the jack, so no more movement.It worked perfectly so the black nylon braid stays intact and does not expose the wires. I didnt feel that deserved one less star, since it was something that I could fix plus the price was good too. I think that the braid being loose was good as well so that you could see if there was a problem in the jack once it was opened as opposed to after its installed and it doesn't work. Compared to other jacks that cost 2x-4x more for the same purpose whats to complain about even if you have to buy another one its still cheaper. As for the pins several people stated that they broke or bent them I had not issues as it didnt require brute force to insert these in. Common sense should tell you that its not going to withstand forcing it into a connector or applying a lot of pressure. I can neatly tuck the wire on top of my rear view mirror when my detector is not in use. It has the correct voltage, and included small black zip ties, so after inserting the pins I gave a little slack and zipped the cord to the connector so there is no pull on the cord when connecting and disconnecting.I would buy again especially when the name brands and radar sites sell these at ridiculous markups. I think its important to note that I am not using a mirror mount I am using the Magnet Mount that came with my Escort IX. setup is clean and no hanging wires.
T. Vo
Reviewed in the United States on August 26, 2017
Works perfectly and tapped directly into my headliner lighting unit, as opposed to the mirror. Installation is harder than described, unless you're an experienced car tech. I attempted to do the tap myself, but it's a bit challenging in an 2013 BMW M3. There's not much room, not wiring access to tap into, so I instead paid a car stereo installer to wire it up for $40. Well worth the money and you'll avoid all the frustration. Now my Escort looks clean and factory install, without the cigarette power cord running down my windshield.
Edgar
Reviewed in the United States on August 21, 2017
I finally got the chance to install it and it's crap. I wires came out and there's no space to try to put them back in the little adapter to fix them. Only after 2 months of install so I wouldn't recommend it and I would not buy it again!!!•Update•So after I put this comment we had a couple emails to verify that I purchase from them and they were able to replace the cord for free this products is great looks good and they will work with you!!Update 4/2/18This thing broke again! My radar wasn’t getting any power it it and I disassembled everithing to see what the problem was, I noticed the small needle like prong comming our the black house was broken! I love this product because I don’t have to have the original wire all in here and because I love to no be able to see wires but honestly I don’t know if I would buy again and just keep having to buy them often! What should I do?
ZH
Reviewed in the United States on July 15, 2017
Could you make your own version of this cable for about 2 bucks in parts? Sure you can, but few of us have time to do so. Anyway, this thing does work as advertised, I inserted the contacts into the power harness of my 06 MDX Rear view mirror and wrapped some duct tape around it so that the connectors wouldn't fall out. Plugged the RJ11 connector into my Escort and I must say it works perfectly and I saved at least $25 over the more expensive Blendmount version. I'm taking off a star because the mesh wire jacket did come out from the RJ11 connector but its not that big of a deal and is hardly noticeable.
CG29
Reviewed in Canada on June 3, 2017
Speedy delivery. Easy to install
Henry M
Reviewed in Canada on February 3, 2017
works good
Recommended Products
