Your cart is empty.
Your cart is empty.This is a 1-1/4” to 2” receiver adapter that is 6” long. It enables a 1-1/4” receiver to fit popular 2” accessories such as bike and cargo carriers.
Hi
Reviewed in the United States on March 11, 2025
very strong and sturdy build. Much stronger than the cheaper ones.
Billy M Shuffield
Reviewed in the United States on April 15, 2025
thanks
Bike Rider
Reviewed in the United States on February 1, 2024
Got this because of the positive ratings.Opened the package, went to slide it in to my receiver and it won't go.Corners are square and my receiver (Drawtite) is slightly rounded.I'll try hitting it with an angle grinder to cut the corners just a bit.
Justin
Reviewed in the United States on December 7, 2024
Great hitch. Very solid and worked well
Shawn D
Reviewed in the United States on December 17, 2024
Works so far to adapt small reciever to the standard 2” receiver.
John J
Reviewed in the United States on December 15, 2024
Sturdy/strong and at a good price point!
Larry W.
Reviewed in the United States on December 15, 2024
Makes smaller hitch mount a little bigger for more uses
Jose Nova
Reviewed in the United States on June 29, 2021
My 1 1/4 inch receiver had a small weld drop inside the receiver that acted as a stop. I could not inset this adapter far enough to insert the pin. Reese product support said that this was done occasionally to be sure to comply with the capacity of the hitch and recommended cutting a small bit off the the 1 1/4" end of the adapter so the pin hole was accessible. I did that and the adapter now fits. BE ADVISED - the 1 1/4 inch end of the adapter is solid metal and I used my air tool cutting wheel to cut off about 3/4" from the end. Even with the air tool, that took a while and I used up one cutting wheel. To make that cut with a hacksaw would take a loooong time. If you decide to do the cut, MEASURE CAREFULLY!!! And be patient. Kudos to Reese product support - they gave me the confidence to do this.
Recommended Products