Your cart is empty.
Your cart is empty.Product Description
How to install？
1. Drill holes on the wall or wooden board according to the holes on the bottom plate.
2. Fix the base plate to the wall or wooden board.
3. Place the adapter rod on the base plate, insert the screws, and tighten the nuts.
4. After pushing the bracket into the bottom of the Starlink dish, clamp it accordingly to prevent it from falling off.
5. Tighten the Starlink dish and connecting rod with screws to fix them in place，and adjust the tightness of the screws according to the size of the rod.
6. After installation, check if all the screws are tightened and then start enjoying your high-speed network.
LRS
Reviewed in the United States on March 6, 2025
The kit came with all required parts and was easy to assemble and install. I am not using it to mount a Starlink antenna (yet) so I can’t comment on the Starlink adapter, but the mount and mast worked well to mount a cellular antenna.
MJ
Reviewed in the United States on March 5, 2025
Using this to mount an outdoor HDTV antenna so it clears the roofline. The kit is perfect for this application, and fits together as necessary. Was easy to figure out and get setup. 5 star product...
Customer
Reviewed in the United States on March 30, 2025
A nice sturdy mount system. It dm comes with everything needed to easily install. It has adjustment option which makes it nice as well. I used it to install a regular antenna because of its sturdy functionality.
Tony Parr
Reviewed in the United States on March 26, 2025
Works as should, fits 2” pipe and comes with two sets of set screws as needed.
B H
Reviewed in the United States on December 21, 2024
Setup:This stand is able to extend beyond 6 feet high and the height can be adjusted by the top shaft as well as the bottom shaft as the legs come closer together. At first I wasn't sure if this was compatible with the standard gen 3 starlink that is not the mini, but this one is compatible. I had to learn that the kick stands needs to be removed by pulling up on the tab touching the starlink surface with the kickstand flat to remove the kickstand. Once the kickstand is removed I was able to attach the black base to the Starlink device. I like how I can just leave the base attached to the device to set on top of the shaft when needed. It does take a little bit of time to secure the six bolts that secure the base to the shaft, but it's not too bad if you tighten and then loosen just enough to take off. It's also nice how there's a pin that supports the weight of the top shaft and device when you are raising and lowering the top shaft. I wish the chain was a little longer though as it can get in the way. The pin slides through the full shaft giving the shaft a good solid stop from sliding down further.Rotation:The only potential downside worth noting is that when it's fully installed, tightening the knob and/or bolt on the shaft doesn't stop the top shaft from turning the device very well. This may be a good thing if you want it to give a little in a storm, but not a good thing if you are trying to avoid the wind from disrupting the angle of the device.
Recommended Products