Your cart is empty.
Your cart is empty.Complete set with 1 V-block and 1 clamp. The block has four 3/8-16 tapped holes, two in the base and one on each side for attachment to an angle iron. The angle iron holding the block can then be attached to a lathe faceplate or held by a magnetic chuck. The block is hardened and precision ground. The sides are parallel and the V is central and parallel to the sides and base.
Robert Morris
Reviewed in the United States on March 19, 2018
High precision, cheaper than anywhere else
Ram4891
Reviewed in the United States on January 28, 2017
Good tool, at its worst it was .00025 out of square.
Recommended Products
$238.22
$ 99 .00 $99.00