Your cart is empty.
Your cart is empty.Ralph Playdon
Reviewed in the United States on January 7, 2025
Worked well until the red temperature needle colour faded. Then could not read the temperature. Lasted 6 months.
BOB H
Reviewed in the United States on January 11, 2025
works great
Randy Guffey
Reviewed in the United States on April 22, 2025
Works good small but accurate
RetiredTexan
Reviewed in the United States on August 31, 2023
Installed using supplied sticky pads on passenger side rear view mirror of 2018 Honda Odyssey. Stayed on for a few weeks, but fell off while on vacation in warm humid Florida Gulf coast.Temp readings were very close to vehicle dash read out. Vehicle dash read out is in lower left corner and in small font, difficult for driver to read and impossible for passenger.
Qmsp
Reviewed in the United States on July 8, 2023
Difficult to read due to its small size.But it is extremely accurate
fred
Reviewed in the United States on June 4, 2023
Adhesive tape to mount this does not hold up.Thermometer fell off my outside mirror while traveling; so it is GONE!!!...HISTORY and cannot be found!!!!!
John W Friesen
Reviewed in Canada on January 23, 2023
See headline
Khlomaki
Reviewed in the United States on September 25, 2022
Update: I’m no longer certain about the calibration process of using ice water. Apparently ice water can be 32°c or below.I ended up using an infrared thermometer to calibrate all twenty-odd Taylor analog thermometers and they do all hold within a degree. Unfortunately I haven’t figured out how to calibrate or know the temperature is accurate without having a base.I’m writing this review in response to all the bad reviews. I bought this temp gauge mainly because one review here mentioned the calibration screw on the back so I calibrate myself if it wasn’t already. But it is calibrated. I put it in a glass of ice water and it registered 0°f/17.8°c (decimals are not included in the dial, but that’s what 0°f is and it reads 0°f) If you do the ice water test and it doesn’t read 0°f simply use one of those tiny flat head screwdrivers, or equally as good, use the tip of the nail cleaner that comes with your nail clippers to turn the calibration screw on the back of the device until it reads 0°f.I was unable to find anywhere here nor on the Taylor site where it states there’s a calibration screw on the back. It makes a huge difference and it should be included.It can be mounted in either direction, it comes with adhesive mounting stickers. Is bilateral the word I’m looking for? Maybe. Anyway, I will be using this temp gauge in a bearded dragon enclosure. I hope this review helps your decision.P.s. i don’t know how to rate how easy it is to read. It’s under 2” in diameter so it’s exactly what you’d expect for something that small. If you typically require reading glasses then you will most likely need them to read the dial.
The Captain
Reviewed in the United States on March 29, 2021
Completely, totally, without question, no doubt whatsoever, cheap, worthless CRAP!!!!!
Recommended Products
