Your cart is empty.
Your cart is empty.Brian Hamilton
Reviewed in the United States on August 26, 2024
I bought this for a replacement for a bass boat. I hooked up one switch to a panoptic black box ran it on and off for a day and the switch stopped working. I switched to another switch it did the exact same thing. After further investigating I noticed the switches was getting hot and the back was melting and shorting out on the wire prongs. Its a nice looking panel just not good for my application.
Charles k
Reviewed in the United States on August 23, 2022
I'm using it in my camper for the 12v circuits
Gnetric
Reviewed in the United States on May 22, 2022
Installed it in my boat and the whole thing started to fall apart on me. While it looks good from the outside, the plastic material that they used are so thin and britle. I had high hopes that I will get to enjoy my new rocker switches. However, I did not even get to take my boat out to sea and the whole thing just literally breaks apart each time I touch it. I guess it's much better to find out that now than finding it out while im in the middle of the ocean. Seeking low cost solution... sometimes gets you inferior product. Invest your hard earn money else where.
jeffrey hathcock
Reviewed in the United States on November 4, 2022
Works ok but I wanted to swap the positive and negative, but unable to account of the led bulbs so it works fine
843Realtor
Reviewed in the United States on August 5, 2021
Works great and looks great
clifford
Reviewed in the United States on July 1, 2021
Looks nice but cheaply made switches. The blades on the switches will fall out if pushed at the wrong angle. Main power is wired to the volt meter and usb ports so it's always on unless you have a master disconnect, or want to rewire the switch panel
Jessica
Reviewed in the United States on December 30, 2021
A little bit more directions would have been nice but easy to figure out.
Mayson Marie Leatherwood
Reviewed in the United States on June 20, 2020
Panel was just what was described. Fit my application to a tee. I knew I would have to separate switches to accomplish all my requirements.
Recommended Products
