Your cart is empty.
Your cart is empty.Product Description
HatchetKing420
Reviewed in Canada on March 31, 2025
Good back probes, works with multimeter perfectly
smp
Reviewed in the United States on February 2, 2025
Great set of backprobes for equipment/automotive diagnostics.
Electronics Engineer
Reviewed in the United States on February 13, 2025
These work well and keep you from having to switch whole probe sets to probe fine circuits. Slip over standard probes, come in black and red to maintain your polarity orientation. Would have given 5 starts but they are not hardened in any way- they bend and keep a bend. Would be nice if they were like a straight pin kind of stiffness, more a like a paper clip currently. Straighten easily but I'm sure all the bending and straightening will wear them out. Good overall.
Green Probe
Reviewed in the United States on August 9, 2024
These needle probes are very sharp, and they fit onto a standard probe tip snugly. They are flexible, and return to straight. After buying a set, I use them more than I'd imagined. It's quite useful to be able to insert the needle probe where you need it, then insert the standard probe tip, or clip on an alligator tip. Also, being able to leave the needle probe in place while using your multimeter elsewhere is nice. I like the short probes for testing SMD components. These are thinner and much sharper than the screw-in type needle probes I have. With my old probes I had to press harder and work the probe into the solder to get a reading. These puncture oxidation and conformal coating easily, requiring much less force to get a good connection. They also puncture wires easily, and fit into tighter spaces for back probing or powering connectors.
Jayson Zimmerman
Reviewed in the United States on June 18, 2024
These probes are extremely sharp, like a hypodermic needle. It takes a little bit of effort, but it did completely slip over my existing test lead probe. The long probes are pretty good at resisting being bent. Be advised that once you poke a hole in the wire insulation for measuring voltage, that piece of wire is no longer considered waterproof. Ideally you should go back and seal over the hole with liquid electrical tape.
JULIO
Reviewed in the United States on June 15, 2024
OK
Eddie Lanehausen
Reviewed in the United States on May 28, 2024
I still need the leads.
KEVIN KINSEY
Reviewed in the United States on May 2, 2024
They are sharp enough to go through conformal coating, and because they're stainless steel, pretty strong as well.
Rene P
Reviewed in Canada on November 9, 2024
C'est très bien les connecteur sont de plus en plus petit et pour fair les test il faut être capable que la sonde du multimetre ce rendre aux terminal attention les doigts ca pique
Me perdieron buena compra gracias
Reviewed in the United States on October 28, 2024
En quedaron ala perfección en mi aparato
Recommended Products