Your cart is empty.
Your cart is empty.Product Description
If you are looking to upgrade your stock coil or want to complement the performance of your MSD 6-Series Ignitions, our blaster coils are the right choice. For MSD Ignition applications. With a stock points style ignition, a ballast resistor must be placed in-line with the positive terminal of the coil. These blaster coils are supplied with a 0.8 ohm ballast resistor plus a terminal and boot to fit most applications. Mallory Melonite applications also require the ballast resistor.
From the Manufacturer
If you are looking to upgrade your stock coil, or want to compliment the performance of your MSD Ignition, This line is the right choice. Special windings are used to provide maximum build-up of voltage...45,000 volts, 15,000 more than stock! These windings are held secure and kept cool in an oil filled metal canister. The tower assembly is molded of durable alkyd material due to its high dielectric characteristics.
SPECIFICATIONS
- Blaster 2 Kit - Red, For Points, Electronic Or Msd Ignitions
- Primary Resistance: .7 Ohms
- Secondary Resistance: 4.7K Ohms
- Max Voltage: 45,000 Volts
- Inductance: 8 Mh
- Turns Ratio: 100:1
- Peak Current: 140 Ma Spark Duration: 350 Us
WARRANTIES
- One Year Limited Warranty
Customer
Reviewed in the United States on January 12, 2025
MSD dam good name for automotive products
patti lover
Reviewed in Canada on November 16, 2023
Perfect
Rolando encalada
Reviewed in the United States on July 16, 2022
Excelente inversión
P******
Reviewed in Canada on October 29, 2020
Shipping rapide et item parfait a+++
Siehnel, Gary
Reviewed in the United States on August 26, 2019
good packaging...came on time....easy to install...great performance...
l_chuchu_8a
Reviewed in the United States on September 9, 2018
MSD quality always stands high, using it on an older inboard boat motor.
Customer
Reviewed in Canada on June 28, 2018
I have a 1978 Dodge Motorhome that the coil was showing some signs of age. This is king of class for replacment, the extra resistor was perfect aswell..
Client d'
Reviewed in Canada on December 13, 2018
Merci beaucoup !
Higgybear
Reviewed in the United States on October 15, 2018
I found out the hard way that this coil CANNOT be mounted in any other orientation then vertical. not even a little.. After speaking to tech support at MSD the Blaster 2 can overheat due to oil inside not covering the internal coils.My car after about an hour of driving would sputter and be hard to start. I change fuel filter thinking maybe it got clogged. It happened the first time right after a fillup. However if the car sat for awhile it ran fine. but a few mins later again same issue. Other than that great product. I did however change to a 8222 that can be mounted anyway...
waredneck78
Reviewed in the United States on January 3, 2016
Woke up the ol 302. Got the package 4:30 installed and running 5:30. I bought this because my old coil on my f150 was going out and this was a direct wire in because I had the tfi ignition. 3 problems but not really at fault for this product. 1: finding a mounting location was tough but I ended up removing my old coil and hose clamping it down. 2: after you remove the clip and cut the 2 wires there isn't a lot extra. Lucky I had some spare 14 or so gauge wire laying around. 3 if your coil wire is a 90° angle fit you have to splice the wire. But this coil makes it idle so much better and run even better. Instead of half the pedal to move the truck it takes maybe quarter.
Derek M.
Reviewed in the United States on July 8, 2015
These kits are so incredibly easy to install. The directions are very forward, everything is easy to put where it needs to go. The first thing I do on any 924 or 944 I buy is install one of these since the Bosch coils are usually so old they are nearing the end of their life. One thing worth noting is that the resistor packs are nice to have, but depending on the setup may not be necessary, so read the directions carefully since some cars do require them.In tandem with the MSD 6AL unit I purchased, my ignition feels night and day better.
Will&Erin
Reviewed in the United States on October 2, 2015
Stock coil died on my 1986 BMW 325 and new Bosch unit was just under 200$. After doing some research found out that this was a plug and play replacement for late 80's early 90's M20 BMW's. Would definitely buy again!
david
Reviewed in Spain on October 17, 2015
Envio rapidisimo, producto de mucha calidad, funciona perfectamente en mi alfetta gtv 2.0. Muy buen precio y producto. Da un look mas vistoso al motor con su color rojo.
Recommended Products
$11.59
$ 5 .99 $5.99