Your cart is empty.
Your cart is empty.DG
Reviewed in the United States on February 13, 2025
Very nice a lot better than factory would buy again easy to install.
David Balla
Reviewed in the United States on July 7, 2024
I have used the name brand type of these bump stops and I don’t see any difference. I hope the hold up as well. Haven’t put a load on the yet. Spray soap ie a must to install and a good pry bar to power them in the holders. I am satisfied .
JK
Reviewed in the United States on July 26, 2024
Easier to install than I anticipated. Just heat in hot water and grease the base. Pressed into place.Much better than OE.
Kevin Stephenson
Reviewed in the United States on July 13, 2024
The bumpers fit as designed. They are super stiff. When towing my boat, they are not riding on the frame (not that much sag because of proper tongue weight). But when you hit a bump, be prepared. They send a shock through the who truck. Bouncing up and down. This caused unsafe driving conditions. I cannot recommend them because of this. Pulled them and returned them as soon as I got back from my first road trip towing a trailer. (I have been trailering boats/rv for many years, so trust me when I say this made the performance unsafe)
Naser
Reviewed in the United States on December 8, 2024
Nice design
Gerardo
Reviewed in the United States on December 20, 2024
Way too bouncy when hauling an empty trailer or light load. Once trailer is loaded it’s very helpful. They are very easy to install. I decided to uninstall these and only use when hauling a trailer.
Jose maria
Reviewed in Mexico on December 10, 2024
Brincan un poco pero buenos
Layton Espinoza
Reviewed in the United States on October 22, 2024
If you don’t have a leaf spring system in the back it doesn’t technically fit but I was able to get it installed and it’s substantially reduced the burden my rear springs were taking alone. Good product and very easy to install
KO
Reviewed in the United States on April 7, 2024
These bump stops are solid rubber and substantially longer than the OEMs. Install with some silicon and a pry bar took about 15 minutes. Putting them to work hauling a trailer tomorrow and have no doubt they’ll do the job.
Recommended Products