Shopping Cart

Your cart is empty.

Your cart is empty.

ShangHJ Timer Delay Relay AC110-220V 10A 1500W Programmable Cycle Timer Switch ON-Off Control LED Digital Display Time Relay Module(Pack of 2 Pcs), Green,red

Free shipping on orders over $29.99

$16.99

$ 8 .99 $8.99

In Stock

1.Style:Dc12v/20a


About this item

  • Support multiple types of working mode including timing, cycle and cycle working modes meeting your most demands. Please pay attention for your first use. You need wait 6s after your setting data, the module will save you have set after 6s.
  • Time ranging from 1 second to 999 hours. Double LED displays, so you can set two timing time T1 and T2. Six operating modes for your choice.
  • Dual LED Display: On-board dual green-red LED display module and tactile push-button, which is easy to set the delay time and working modes(Red readout for practical value(PV); green readout for set value(SV).
  • Supply Voltage:AC110-220V 20A/1500W(Max). Size: 79 X 42 X 26mm. (New and Old Models are Sent Randomly)
  • Three timing time for choice: P0--0: T1 timing for Seconds (0-999s); P0--1: T1 timing for Minutes (0-999m); P0--2: T1 timing for Hours (0-999h). You could set the timing mode as your requirement.


Parameter:
Timing Range: 0-999s, 0-999min, 0-999h
Relay type: Normally open relay
Supply Voltage:
DC12V 20A/240W(Max)
DC24V 20A/480W(Max)
AC110-220V 20A/1500W(Max)
Size: 79*42*26mm, Hole size: 72*40mm
Product Functions: Timing, Delaying, Time Cycling & etc.
Features:
P0--0: T1 timing for Seconds (0-999s).
P0--1: T1 timing for Minutes (0-999m).
P0--2: T1 timing for Hours (0-999h).
P1-0 Load is off until (T1 or PV) time counts down to 0 then the load will come on and stay on.
P1-1 The load comes on as the power button is pressed. After PV Time the load will go off.
P1-2 The load is off for (T1 or PV)(delay time) then the load switches on and runs for the time set in (T2 or SV) then switches off until power switch is pressed to cycle again.
P1-3 Load is on until PV Time runs out Then after SV time runs out the load will come on and stay on.
P1-4 Load is off until (T1 or PV)(Delay) time counts down to 0, then load comes on until SV time counts down to 0 then the load is off then it cycles again and again-auto cycle.
P1-5 The load is on until (T1 or PV) time counts down to 0 then powers down and after (T2 or SV)Time counts down to 0 the load will start working and cycle again and again-auto cycle.
Note:
Please pay attention for your first use. You need wait 6s after your setting data, the module will save you have set after 6s.
Package Includes:
2 X Timer Delay Relay AC110-220V 20A


karen wolf-schneider
Reviewed in the United States on August 10, 2023
I used it to limit the charger time for our E bikes. so they're not to often charge the batteries to full, hope it helps to extend their lifetime. The included manual is useless, several Youtube videos are extremely helpful
Sergio López
Reviewed in Mexico on July 5, 2023
Con el uso de este timer evité la compra de un PLC el cuál evidentemente es más caro. Lo utilicé para limitar el tiempo de calentamiento de un vapor sauna y funciona como proteción para evitar que se dañen las resistencias si lo llegaran a dejar prendido, ya que se apaga solo después del tiempo programado.
J Marie Schmidt
Reviewed in the United States on May 2, 2023
Has 5 different programs. Go to Youtube to see Demo videos.
David
Reviewed in Mexico on December 4, 2023
Los tiempos programados del relay no coinciden con el cronómetro. Compare el relay con 5 temporizadores y nunca coincidió. Ninguno de los 2 relay funcionan correctamente. No sirven.
Aaron Penning
Reviewed in the United States on June 22, 2022
This device was relatively simple to wire once I actually took the time to study the 110V diagram. The relay is initially set in seconds, and I ran it for 180 seconds and 900 seconds (3 and 15 minutes). Both resulted in it shutting off at the exact time. However, when I changed the units on the relay to minutes, I ran it for 3 minutes and timed it. The relay shut off at 2:30 seconds. It's kind of odd but something must not be programmed right as it seems to shave off 10 seconds for every minute it is set for.
Kristie
Reviewed in the United States on June 19, 2022
Great item
William G
Reviewed in the United States on May 13, 2022
I bought it to turn a device on and off, at different set frequencies for both the on and off cycles. So I bought a nice round extension cord, 14GA, cut it, and then tried to wire it so the outlet (jack) end would be controlled by the relay.Well, 14GA is too large for the wiring lugs. I also have to make several splices for this to work as I need feed power in twice and the load & feed shares the common. It’s really simple… once you figure out what the heck the device is doing.The instructions weren’t very clear. My electrical engineering classes were decades ago. So I would look at their diagram, read the notes, and then only after I poke around with a multimeter does it become clear what they were trying to explain.TL;DR- It works fine. It’s versatile. But directions are vague so you either need to know how it works or be able to troubleshoot with a multimeter.