Shopping Cart

Your cart is empty.

Your cart is empty.

Shielded 2-Conductor Guitar Circuit Wire hookup wire 6-Foot 24 AWG

Free shipping on orders over $29.99

$6.99

$ 3 .99 $3.99

In Stock

About this item

  • 2 conductor
  • Reduce unwanted electrical noise by using shielded wire for your longer wiring runs (for example, the connection between the controls and the output jack)
  • Covered with polyethylene insulation, which is surrounded by an outer conductive shield, which is connected to ground.
  • 3mm outer diameter


Shielded 2-conductor hookup wire. Used to gain tonal flexibility, allow coil cuts, combine the coils in series or parallel, or wire the coils in-phase or out-of-phase.


Customer
Reviewed in the United States on January 11, 2025
needed a shielded cable for audio lines in an old radio i was restoring . filled the bill.
bruno
Reviewed in the United States on December 18, 2022
Wiring is much too heavy, and cumbersome..very difficult to use in certain situations.
Customer
Reviewed in the United States on June 6, 2020
Good wire haven't used it yet but looks good
FRED JELLA
Reviewed in the United States on July 22, 2019
Does its job
Jeffrey Geile
Reviewed in the United States on March 10, 2017
As 0desc
Larry C.
Reviewed in the United States on July 21, 2016
Very nice wire an handy for runs from guitar input jacks and at least the neck pickup to the control compartment. Easy to work with. Just be careful with those pickup wires. They are easily "gooched" if you pull on them.
Recommended Products