Your cart is empty.
Your cart is empty.Product Description
279834 Dryer Gas Valve
279834 Gas Valve
debkor
Reviewed in the United States on March 15, 2025
These are amazing. I purchased ones before this company that were a little cheaper and they only worked for a week. These have been great for a few months now and I am very pleased. They were simple to replace! Highly recommend!
Jake Cogswell
Reviewed in the United States on April 11, 2025
For the error code E1 of our dryer, this turned out to be the fix. When the internet tells you it is one screw for the cover, though–trust me–it's two. They work great.
John From Michigan
Reviewed in the United States on July 22, 2024
My Maytag gas dryer developed an issue where it would work when cold, but after a single heat cycle the flame would stop working. I measured the resistance of the two gas solenoid coils, and found that the main coil (with three contacts) had an open on the center leg when hot, but continuity when cold. Aha, bad coil.I ordered a replacement coil set from another "Blue" parts supplier on Amazon, and the secondary coil (the one with two contacts) wouldn't fit over the solenoid shaft. The main coil (my bad one) did fit, however, so I installed it.Again, when my dryer was cold, the flame would come on, but when hot there was no flame anymore, and a loud buzzing sound could be heard. After loads of troubleshooting and thinking that I may have to buy an expensive burner assembly, I tried another coil set, this set.Viola! Both new coils fit the solenoid shafts properly, and my dryer heat now cycles normally. The previous coil set (which cost a bit more than these) were junk.I highly recommend DR replacement parts based on this experience.
Dennis M
Reviewed in the United States on November 20, 2024
It was hard to diagnose the faulty component on my dryer since the gas would light for 5 to 10 mins but stop thereafter. The old parts would in fact pass the volt meter test too! The issue was my old ones were 'weak' and would stop working after the heat.So if you are not sure why you have intermittent heat, try these, especially since the cost is rather low and it is easy to unplug and replace.I have a Whirlpool Duet Steam. 11+ years old.
Rosanne
Reviewed in the United States on November 18, 2023
My magtag dryer quit heating a couple of weeks ago. My husband who is very handy, thank goodness, was able to diagnose that it was this part. He was able to open the dryer door and easily install the part into the dryer. After installation, it was time to test if it would work. I had my fingers crossed! We started it up and it if oted and kept running and heating the dryer! I was so happy. We had tried another part before and it didn't work. It has been a couple of days now and still working like a champ. You just can't beat those old Maytag. The part shipped very quickly. We also received it very quickly as well. I just had to wait for my husband to install it.I would definitely purchase this item again. The description on the order was very good and I was able to find that this particular part worked for my specific dryer. It fit perfectly!I was worried about what the price would be since my dryer is at least 25 years old ( have I mentioned that the old washer and dryers are the best?). Anyway we found this part and to my surprise, it was under $10, and we got 2 of them! I am so thankful for a handy husband, and for this inexpensive part that fixed us right back up and I am again able to dry all this laundry! Thank you!!
Buddy!
Reviewed in Canada on September 29, 2022
I can fix a lot of things with an engine but when my dryer stopped working I thought it was toast. Bought this and it fixed the problem of it just spinning and spinning but no heat. Hope this helps someone save some money
RW
Reviewed in Canada on September 18, 2022
Product worked well. Price was reasonable. The delivery was good. Would definitely recommend it.
Günther
Reviewed in the United States on February 1, 2022
UPDATE: After all the info below, this part was not the fix, the new coils measured almost identical resistances to the in-service coils, therefore my dryer’s issue is still there. The only thing that still bugs me is that these coils don’t measure what the technical service document says they should measure. If I find the fix, I’ll post it here.I purchased this very item (kit) in February 2019. Well, back then they were the fix, but 35 months later the same issue of clothes taking longer to dry has returned. This "kit" # 279834 is the way to go, see my comments below. However, I will not buy this same product again, I want to try a different third-party manufacturer of the kit (279834), to see if it lasts longer than 3 years.If you have a Samsung Model DV328AGW/XXA, your Gas Valve Assembly should be 25M01A Type 128. This Gas Valve Assembly was made by White-Rodgers, who designates this by their own MFG P/N 25M01A-100 (Universal Replacement Clothes Dryer Combination Gas Control). Also, the label on the Gas Valve Assembly reads Maytag (Customer of White-Rodgers) Part No. 6-3061760. In short, this is a White-Rodgers manufactured assembly, made for Maytag (purchased in crazy bulk?), and Maytag appears to have re-sold these to Samsung for installation in their dryers.Noting the above, the 25M01A-100 utilizes Secondary Solenoid Coil Model Number F91-3889 (single coil, two pin) and Booster/Holding Coils Model Number F91-3890 (dual coil, three pin). According to this listing, for Ultra Durable # 279834, it is a third-party manufacturer of this kit/set of two solenoids. The # 279834 actually refers to the Whirlpool Dryer Gas Valve Coil Kit 279834, and it is equivalent to the two White-Rodgers solenoids. By the way, White-Rodgers is a division of Emerson Electrical Co. Also, remember that # 279834 is manufactured by Whirlpool, and the individual OEM solenoid coils are manufactured by Emerson and likely White-Rodgers, I'm sure there's more out there, just adding to the confusion.Anyway, searching online appliance stores, they cross-reference the Kit # 279834 (two solenoids) to be able to replace individual solenoids F91-3889 and F91-3890 (among other part numbers). So yes, this is good for use on many Samsungs, in particular, those whose Gas Valve Assemblies are White-Rodgers # 250M01A-100 (25M01A Type 128) or Maytag P/N 6-3061760.
Creme brulee snob
Reviewed in Canada on January 29, 2022
18 yr old Whirlpool gas dryer wasn’t heating properly. Diagnosed the easiest and cheapest parts to repair first starting with the solenoid. This was the parts I needed, changed them out easily, and we have a hot dryer again.
Heather hubers
Reviewed in Canada on November 16, 2021
Other sites wanted 80 dollars just for a secondary coil. Amazon was in my ballpark.
Cai Y.
Reviewed in Canada on October 22, 2021
It saves my gas dryer and much money, I don't need to buy a new one!
Recommended Products