Your cart is empty.
Your cart is empty.Product Description
UniFormation PLA-Bsed Photopolymer Resin
Precautions
Recommended usage temperature: 25-30°C（77-86°F）.
Shake up the bottle before use and avoid direct sunlight and dust.
Wear gloves before use, avoid direct contact with the skin, keep the room ventilated.
Make sure the LCD screen, build plate, and resin vat is clean.
If cause allergic, please seek medical care immediately.
Once the model printing is complete, please wash it with ethanol alcohol (recommended concentration of 95% or more, the higher the better).
Storage
Keep away from fire or direct sunlight.
Store in a sealed, shading, and cool place.
Keep out of reach of children.
If resin didn't run out, filter the resin with a filter funnel and pour it into an empty container.
ALB
Reviewed in the United States on February 27, 2024
Color is a very light peach, closer to flesh tone than orange. Very disappointing.
Ian
Reviewed in the United States on October 15, 2024
I have used my resin printer before for years. Even after following the recommended settings my prints constantly failed and I only had one successful print. This resin HAS to be warm in order to adhere so you almost have to run a heater while you print. Will never buy again.
Boaz Dabush
Reviewed in the United States on April 6, 2024
Easy printing, results accurate products, good surface.
Kevin Hernandez
Reviewed in the United States on April 21, 2024
My first bottle was when i bought my uniformation gktwo printer. It printed in amazing details however, like older resins, it was Super brittle! I had printed a small Mandalorian helmet and it fell from about 3ft of height and it shatter into about 9-10 pieces. It was so bad i couldn't just glue it together like when minis would fall. It may be great if you mix with some flexible resin, but honestly not great by itself compared to ABS like resin, yet better than some water washable ones.Bigger pieces (1/2 inch thick) are a bit sturdier and have fallen with no issues. eg that same helmet at 100% scale.I do recommend this for bigger prints in which you want details like 6+ inches bust prints.
3DHP
Reviewed in the United States on September 1, 2023
This resin is what I would call pour and go. Prints perfect with no issues on my GK2 8k Uniformation resin printer.In picture are 2 of the prints I have used it for.Uniformation has 3 other colors I have not tried yet. I would recommend as it printed perfect for me.
M. Smith
Reviewed in the United States on February 12, 2023
This is THE worst resin I have ever purchased. It doesn't turn solid at ALL. you may get a few solidified strands that'll mess up the entire vat but thats it. I've tried mixing it (25 % Uniformation 75% real resin) with ACTUAL WORKING resin, and it kills those resins as well making them usless!!! I tried for DAAAAYS to get it to work but EVERY. SINGLE. PRINT. FAILED. Its basiclly just black sludge that does nothing.
Brian T.
Reviewed in the United States on October 20, 2022
Even on a saturn s mono lcd. Exposure is about 6.5 seconds. Had to do about 35 seconds base layer exposure to get adhesion and not have drooping in my parts
daniel
Reviewed in the United States on October 12, 2022
Perfect quality, will definitely buy again!
Recommended Products